Rigol DM3058 Specifikace stáhnout pdf (Strana 249)

RIGOL

Programming Guide for DM3058

7-11

The programming steps——Agilent Commands:

0 *CLS /*clear the instrument state*/

1 cmdset□agilent /*Select Agilent commands*/

2 *IDN? /*Query equipment ID to confirm if the

instrument works normally*/

3 /*Connect the test leads under DC voltage measure mode*/

4 conf:volt:dc□<range> /*Set the DC voltage measuring function and the

range*/

5 calc:stat□on /*Enable math operation function*/

6 calc:lim:low□<value1> /*Set the lower limit*/

7 calc:lim:upp□<value2> /*Set the upper limit*/

8 calc:func□lim /*Enable limit operation function*/

9 calc:stat□OFF /*Exit math operation function*/

Remarks:

1. Before sending line 4 command , the instrument should be connected under DC

voltage measure mode.

2. In line 6 and 7 commands , parameter value2 should be greater than value1 and

both of them should be within the scope of the range.

3. When using line 8 command to enable limit operation function, no value is

returned if the input voltage is within the scope of the upper and lower limits, else

a beep is generated (the beeper must be on) and no value is returned .

4. Users needing a returned value in P/F test are suggested to use RIGOL

commands.

1 2 ... 244 245 246 247 248 249 250 251 252 253 254 ... 263 264

Žádné komentáře

Rigol DM3058 Specifikace Strana 249