Rigol DS1104B Uživatelská příručka stáhnout pdf (Strana 137)

RIGOL

User’s Guide for DS1000B Series

3-1

Chapter 3 Application Examples

Example 1: Taking Simple Measurements

The function is used to observe an unknown signal; to display, measure frequency,

and peak-to-peak amplitude.

1. To quickly display a signal, please do the steps as follows:

(1) Set the probe and the channel attenuations to 10X.

(2) Connect signal to CH1 with the probe.

(3) Press the Auto button.

The oscilloscope sets the vertical, horizontal, and trigger controls at the best

status automatically. To optimize the waveform display, adjust these controls

manually to meet the requirements.

2. Selecting Automatic Measurements

The oscilloscope takes automatic measurements on most signals. To measure

the frequency and the peak-to-peak amplitude, do these steps as follows:

(1) Measure peak-to-peak amplitude

Press Measure→Source→CH1 to set the measurement source

Press Voltage→Peak-Peak to select the peak-to-peak measurements and the

result will be displayed on the screen.

(2) Measure frequency

Press Measure→Source→CH1 to set the measurement source

Press Time→Freq to select the frequency measurements and the result will be

displayed on the screen.

NOTE: The frequency, period, and peak-to-peak measurements are shown on

the screen and are updated periodically.

1 2 ... 132 133 134 135 136 137 138 139 140 141 142 ... 165 166

Žádné komentáře

Rigol DS1104B Uživatelská příručka Strana 137