Rigol MSO/DS2000A Series Uživatelský manuál stáhnout pdf (Strana 169)

Chapter 6 MATH and Measurements RIGOL

MSO2000A/DS2000A User’s Guide 6-33

Auto Mode

In this mode, one or more cursors will appear. You can use auto cursor measurement

to measure any of the 29 waveform parameters. Before using this mode, you need to

at least enable one auto measurement parameter and the number of cursors will

change with the measurement parameter enabled.

Press Cursor  Mode  “Auto” and the number of cursors displayed on the screen

is determined by the measurement parameter enabled (different measurement

parameter needs different number of cursors).

Note: No cursor will be displayed if no auto cursor measurement parameter is

enabled or the measurement source has no input. When the waveform is expanded

or compressed horizontally, the cursor will move accordingly.

If multiple measurement parameters are turned on later, you can use Meas.Para. to

switch among at most five measurement parameters that are turned on last and the

measurement parameter currently selected is high-lighted at the bottom of the

screen.

The following figure shows the auto measurement of the delay between two

channels.

Figure 6-11 Auto Measurement of The Delay Between Two Channels

1 2 ... 164 165 166 167 168 169 170 171 172 173 174 ... 316 317

Žádné komentáře

Rigol MSO/DS2000A Series Uživatelský manuál Strana 169