Rigol MSO/DS2000A Series Uživatelský manuál stáhnout pdf (Strana 64)

RIGOL

MSO2000A/DS2000A Quick Guide

CLEAR

Press this key to clear all the waveforms on the screen. If

the oscilloscope is in the “RUN” state (the key is

illuminated in yellow), new waveforms will still be

displayed.

RUN/STOP

Press this key to set the state of the oscilloscope to

“RUN” or “STOP”.

In the “RUN” state, the key is illuminated in yellow.

In the “STOP” state, the key is illuminated in red.

SINGLE

Press this key to set the trigger mode to “Single”, the key

is illuminated in orange. In single trigger mode, press

FORCE to generate a trigger signal immediately.

AUTO

Press this key to enable the waveform auto setting

function. The oscilloscope will automatically adjust the

vertical scale, horizontal time base and trigger mode

according to the input signal to realize optimum

waveform display. Note: auto setting requires that the

frequency of the signal under test should be no lower

than 25 Hz. If the parameter exceed the limit, “Can’t

detect any signal!” would be displayed after pressing this

key and the quick parameter measurement menu might

not be displayed.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 76 77

Žádné komentáře

Rigol MSO/DS2000A Series Uživatelský manuál Strana 64